High stability 6mm dia probe pt100 platinum RTD temperature sensor for dryer equipment

1. Introduction

WZ series of assembling type industrial thermal resistances are designed and produced according to IEC standard, usually with temperature control instruments, recording instruments and electronic regulator supporting the use of, which can be measured directly from a variety of production processes within -200-400 range of liquid, steam and gases, temperature of solid surface.

2. Mechanical Parameters

1) Diameter of probe:4-6mm

2) Length of probe: less than 300mm

3) Length of lead: acuities 2M

4) Protection tube material:S304

3. Other Parameters

1) No. indexing:Pt100

2) Measurement range:-200~600℃

4. Model Definition

5. Similar products

6. Installation

Temperature sensor should be placed as far as possible in the installation position of the workpiece.

Its insertion depth in accordance with the actual requirements, install sensor should be as much as possible to maintain the vertical.

If there is flow conditions which must be reverse tilt installation, this enables full access to liquid. If measure the gas of pipeline, the oblique insertion; when the object of measurement is neither gas nor liquid, the sensor portion should be in close contact with the object to improve the response speed and reduce transmission errors.

High stability 6mm dia probe pt100 platinum RTD temperature sensor for dryer equipment Images